FUNcube Dongle works with Windows 10!

Folks

A quick update for you, I am delighted to announce that the FUNcube Dongle Pro+ works perfectly on Windows 10, in both 32 and 64 bit versions.

There’s no need for any driver updates, by design the FUNcube Dongles have been designed to use drivers already shipped with the operating system, and require no special or separate installation from your SDR software.

Many thanks, Howard

This entry was posted in Uncategorized. Bookmark the permalink.

5 Responses to FUNcube Dongle works with Windows 10!

  1. Philip says:

    HI, with Win 10 I cannot get the control panel 2.002 to detect the FCD pp. I have looked and checked that the FCD is showing in device manager ok.
    I have found that when/if I plug the fcd into another USB port it then shows up in device manager under USB controllers tab. Of course I have deleted this device here and plugged back into the original choice usb port.
    But I cannot get the panel to detect…help please?
    Phil.

  2. Mike says:

    My Funcube Pro+ has died, tried different ports and the FCHid2 no longer will recognize either. Is there a way to get it repaired?

    Thanks

  3. Bob Zinn says:

    My funcube Pro Dongle stopped working when I upgraded my win7 to win10 and I can’t get it to work now. It acts like it is installed and working but there is no zero nil nada signal showing from it in any SDR program I try. Before the upgrade it had been working fine. I even bought a new dongle, thinking the old one had died for some reason.
    It acts as if, somewhere along the ‘chain’ of software between the dongle and the program, the volume setting is set to zero. But I have no idea where this is happening nor how to fix it.

Leave a Reply to Bob Zinn Cancel reply

Your email address will not be published. Required fields are marked *


5 − one =