Folks<\/p>\n
I have had a question about the performance of these units. Bear in mind that we are still optimising these units, and there is a lot of tweaking both in software and hardware that we can do.\u00a0As the primary design requirement is to be able to receive and decode telemetry from the FUNcube satellite, sensitivity\u00a0was the first goal to get right, and it is already\u00a0as good as\u00a0an off the shelf receiver as referenced to this in this earlier post: https:\/\/www.funcubedongle.com\/?p=3#comment-48<\/a><\/p>\n Final performance figures will be distributed once we have finalised things like gain distribution and LNA choice. Sensitivity at present is fine. I have improved dynamic range pretty dramatically in the last few days as a result of using the gain distribution front end that I wrote last week. We are now concentrating on strong signal performance.<\/p>\n Howard<\/p>\n","protected":false},"excerpt":{"rendered":" Folks I have had a question about the performance of these units. Bear in mind that we are still optimising these units, and there is a lot of tweaking both in software and hardware that we can do.\u00a0As the primary … Continue reading