Author Archives: admin

Folks, I have temporarily run out of FCDs due to a delay in the supply of one of the parts, and my latest information is that the part will be available in August. I am aware that Martin Lynch has … Continue reading →

Folks, A new batch has just arrived from the PCB assembler for me to test, so the inventory is good. Many thanks, Howard

Folks, As I write, I have a very few units left in stock, with a further batch in manufacturing that is due early this week. Hopefully we won’t see an interruption in supply, although I did accidentally let the Paypal inventory drop … Continue reading →

Folks I’ll be at the annual Hamvention at Dayton again this year, for a short time so my last order time for dispatch before I go will be Thursday 17 May at 10:00UTC. I’m back on Monday 21 May, so not a long trip. … Continue reading →

Folks All FUNcube Dongles after and including serial number 5890 now have the latest firmware preinstalled. All units purchased directly from the FUNcube website from now on will have this firmware. Many thanks, Howard

Folks Let’s cut to the chase – update your firmware! The latest is 18j. I’ve noted that a lot of people just starting out with the FCD start by using some of the great newer software products out there, like … Continue reading →

Folks I am sure many of you will be salivating over the Raspberry Pi Linux board. I have reports from a member of the FUNcube team who apparently has managed to get hold of one, and that the FCD works with … Continue reading →

Folks In the past couple of months we’ve had some fun sourcing a few of the parts, and so we took the opportunity to over stock on those parts we seem to have occasional difficulty sourcing. Usually, we make batches of 500 … Continue reading →

Folks We have about 200 units in stock as I write, and another 500 on order, so you shouldn’t have any problems in ordering. If you do, please let me know! Many thanks, Howard

Folks I had a delivery this evening form the PCB assembler as promised, and I have just finished fulfilling all of the backorders which will be dispatched on Thursday. I note that there are a few notes on the blog that have accumulated … Continue reading →